Reattach the head stop first otherwise it could fall out.
Tilt and slide doors falling off.
If an off track roller isn t the problem you ll have to remove the doors to adjust and possibly replace the rollers.
Here show you how to install tilt sliding door and how to work.
In that case you only have to lift the door and guide the roller back onto the track.
To remove a bottom supported sliding door lift and then tilt the bottom out of the track.
Lift a bottom supported door such as an sliding glass patio door straight up to clear the bottom track.
The unique sash design tilts and slides parallel to the fixed unit with the touch of a finger.
Step 2 lay the door on a flat surface and tighten the screws in all four corners.
Angle the bottom toward you and lift it a little further to disengage the runners on the upper track then pull it out of the doorway.
Then sharply angle the bottom of the door outward and lift the door from the track.
If the door becomes even harder to open turn the screw in the opposite direction.
Roll the door toward the latch side jamb then turn the adjustment screws until the door is parallel with the jamb.
Do this with a helper.
Align it in the bottom track and then tilt it up.
Fabricated from our system 4500 line this design is a premium door solution for spaces that do not allow for traditional inswing doors.
Tilt and slide door repairing.
After a bit of adjustment the door should roll easily without rubbing on the bottom track.
Remove the screen door from the frame by grasping it on both sides and lifting the rollers off the lower track.
You may also want to check out our step by step guideto adjusting your sliding doors.